Sometimes when i boot my server, the docker is stopped.
I dunno why, i always have to enable it again, otherwise my containers dont come up.
Is there a reason for this? How can i make sure, its always enabled?
I just noticed that all are called buttons now instead of switches.
So you should use the service call: button.press i think
So then u can turn it off.
Is there a reason why all are buttons now instead of switches?
In home assistant , what do i do then?
Turn off the button using call service button.press?
I'm having issues with unraid and emby
I'm not sure where to look cause it worked for years.
I even upgraded my server with new mobo/cpu/ram
Did clean installes of emby on my omsc device too
Edit: issue fixed, was a network issue with same ip
unraid-syslog-20231118-1643.zip
embyserver (1).txt
kodilog.txt
How do i know?
I unassigned it and took it out
So i should put the 6 tb parity back as parity and at disk 1 leave it blank and say yes to:
"Start will disable the missing disk and then bring the array on-line. Install a replacement disk as soon as possible."
?
Ok i tried parity swap
Followed this video
When i enter the 8tb instead of the old parity 6tb
And i change the 2tb defect disk 1 to the old parity 6tb, the disks dont show blue and i cant copy the parity information to the new parity...
What now?
i can say for disk 1 to "no device" and keep the parity the old 6tb drive and then i can :
Start will disable the missing disk and then bring the array on-line. Install a replacement disk as soon as possible.
Should i click that?
Do know that the 8tb disk, isnt new either , its an old free nas drive
I might upgrade my other hardware as well.
I'm gonna buy a new mobo, cpu and ram.
Can i just swap after or before my disks swap?
Or is it linked to my unraid license?