pras1011

Members
  • Posts

    893
  • Joined

  • Last visited

Converted

  • Gender
    Undisclosed

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

pras1011's Achievements

Collaborator

Collaborator (7/14)

7

Reputation

  1. I bought a Qnap TS-473A and it's great.
  2. Actually the Toshibas are very good and I would buy them again.
  3. If my spinning hdd read and write speed max out at about 275MB/s when you transfer from PC to Unraid server would 5gb ethernet ports end to end be overkill?
  4. For hdds is a controller with a 2.5gb ethernet enough? Or is 5gb better?
  5. For hdds is a controller with a 2.5gb ethernet enough? Or is 5gb better?
  6. I am not using a switch. How do I turn flow control on? How do I run iperf?
  7. Server bridging and onboard nic has been disabled already. In the future I am planning to get a NUC 13 with a intel i226 nic.
  8. From Unraid to PC speed is about 250MB/s but from PC to Unraid its about 130MB/s. PC is a Nuc 12 with i225v nic with a 1tb nvme. Server has a TP-LINK TX401 10Gbe (Aqauntia Atlantic) nic and Toshiba 20tb MG10 drives. Both are connected to an Asus XT12 Pro mesh router 2.5gbe ports. I am transferring a single 60GB video file to and from each device to test. The server and pc nics are recognised and running at 2.5gbe. I am assuming that the Nuc is fault but what can I do to resolve this?
  9. Reconstruct write was always on. I managed to write a lot longer than 30gb this time before the write speed crashed to 31.5MB/s. I will have to try another computer without the Intel NIC to see is this is the problem.
  10. I got a new server and hdds and on ethernet I get 113MB/s and then after about 30GB of writing the speed drops to 31.5MB/s. I wait till its finshed and then I immediatelty write again and it starts at 31.5MB/s. I cancel it and then give it 10 seconds and then start again and it writes at 113MB/s. But sometimes it writes at 31.5. I unplug the ethernet cable on the NUC and then plug it back in and it works at 113. I am using a Intel NUC with the i225-V maybe its throttling after 30GB?
  11. I have a qnap 473 and I have added a tp link tx401 2.5gbe card but it's not recognised in unraid. I assume I have to disable the 1gbe ethernet ports but I have checked the bios and I cant find the settings to disable them. Does anyone know how to do this?