Hey everybody,
First off: system works normally...
...but:
Recently update my setup, I now have:
Gigabyte Z97P-D3
Intel i5-4460 CPU
16GB memory
Also update the Parity drive to a 4TB WD so I could start updating all 2TB disks to 4TB in nearby future.
So yesterday I added the first 4TB disk and precleared it, however when I wanted to start the array it said it was bigger then the Parity drive. So I did some reading and figured it should be the HPA problem with Gigabyte Motherboards.
I ran:
hdparm -N /dev/sd?
/dev/sda:
SG_IO: bad/missing sense data, sb[]: 70 00 05 00 00 00 00 15 00 00 00 00 20 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
SG_IO: bad/missing sense data, sb[]: 70 00 05 00 00 00 00 15 00 00 00 00 20 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
max sectors = 0/1, HPA is enabled
/dev/sdb:
max sectors = 3907027055/3907029168, HPA is enabled
/dev/sdc:
max sectors = 3907027055/3907029168, HPA is enabled
/dev/sdd:
max sectors = 488397168/488397168, HPA is disabled
/dev/sde:
max sectors = 3907029168/3907029168, HPA is disabled
/dev/sdf:
max sectors = 7814037168/7814037168, HPA is disabled
/dev/sdg:
READ_NATIVE_MAX_ADDRESS_EXT failed: Input/output error
/dev/sdh:
max sectors = 3907029168/3907029168, HPA is disabled
/dev/sdi:
max sectors = 3907029168/3907029168, HPA is disabled
sdg is the Parity drive.. and I haven't found out what that error message means.
Any ideas how to fix it? is it even broken?
Or just swap the parity drive with the new 4TB drive?
Thx in advance!
syslog.txt
WDC_WD40EZRX-00SPEB0_WD-WCC4E7EXTY2N-20160410-1153.txt