pras1011

Seriously???

Apparently not many people are asking for wifi.

Edited the previous post.

I bought a Qnap TS-473A and it's great.

I don't want to. I just need to know how to.

Actually the Toshibas are very good and I would buy them again.

If my spinning hdd read and write speed max out at about 275MB/s when you transfer from PC to Unraid server would 5gb ethernet ports end to end be overkill?

For hdds is a controller with a 2.5gb ethernet enough? Or is 5gb better?

For hdds is a controller with a 2.5gb ethernet enough? Or is 5gb better?

I only found the UK one and it was well hidden.

Wireless unraid?

I am not using a switch. How do I turn flow control on? How do I run iperf?

Server bridging and onboard nic has been disabled already. In the future I am planning to get a NUC 13 with a intel i226 nic.

From Unraid to PC speed is about 250MB/s but from PC to Unraid its about 130MB/s. PC is a Nuc 12 with i225v nic with a 1tb nvme. Server has a TP-LINK TX401 10Gbe (Aqauntia Atlantic) nic and Toshiba 20tb MG10 drives. Both are connected to an Asus XT12 Pro mesh router 2.5gbe ports. I am transferring a single 60GB video file to and from each device to test. The server and pc nics are recognised and running at 2.5gbe. I am assuming that the Nuc is fault but what can I do to resolve this?

Reconstruct write was always on. I managed to write a lot longer than 30gb this time before the write speed crashed to 31.5MB/s. I will have to try another computer without the Intel NIC to see is this is the problem.