ToXIc

ok will preclear it and hold as spare

plz see attached WDC_WD40EFRX-68N32N0_WD-WCC7K6TSYCEL-20220905-1317.txt

thank for you help btw, wished i posted here to begin with

i am took a bit to figure out how to get it to show up.. should i preclear the old drive and trust it?

recreated the log and i see some data not everything but some

i click on the check mark in UD and i get FS: xfs Executing file system check: /sbin/xfs_repair -n /dev/sdx1 2>&1 Phase 1 - find and verify superblock... Phase 2 - using internal log - zero log... ALERT: The filesystem has valuable metadata changes in a log which is being ignored because the -n option was used. Expect spurious inconsistencies which may be resolved by first mounting the filesystem to replay the log. - scan filesystem freespace and inode maps... sb_fdblocks 895215175, counted 902030091 - found root inode chunk Phase 3 - for each AG... - scan (but don't clear) agi unlinked lists... - process known inodes and perform inode discovery... - agno = 0 - agno = 1 - agno = 2 - agno = 3 - process newly discovered inodes... Phase 4 - check for duplicate blocks... - setting up duplicate extent list... - check for inodes claiming duplicate blocks... - agno = 0 - agno = 1 - agno = 2 - agno = 3 No modify flag set, skipping phase 5 Phase 6 - check inode connectivity... - traversing filesystem ... - traversal finished ... - moving disconnected inodes to lost+found ... Phase 7 - verify link counts... No modify flag set, skipping filesystem flush and exiting. File system corruption detected!

got the drive added to the system it shows up in UD but i dont see a "Check Filesystem Status" section in the Disk settings window for the drive the drive is xfs

ok

i have a usb doc that loads drives to UD but it runs 1/3 or the speed. or use sata?

i still have the old disk.. it did say "unmountable" ill review the link

yea i rebooted hoping it would of shown the contents of drive 18, it asked to format 18 when i added 9 to the system and i did, i guess that killed the data? i also have this new section since all this occurred

oh my b i looked at the persistent diagnostic service uploaded logs here and 1st post fatjoe-diagnostics-20220905-1015.zi

unfortunately the service wasnt running

i just uploaded the logs from http://tower/log/syslog should i gather via the method you posted?

Hi everyone, been using unraid since v4 and have replaced many drives since then. recently however was my 1st time 2 drives went bad at the same time. I'm currently on version 6.9.2 and using two parity drives. Before i did anything i noticed that one of the emulated drives showed nothing, my data in some folders were missing. Not thinking too much about it hoping it was a bug or something i proceeded with my replacement process and got my drives preclearing. I swapped them one by one leaving the badly emulated drive last. When i did switch to the 2nd drive the rebuild took over 12hrs and did almost 4tb of write to the drive but unfiortualtely my data still wasnt there.. am i still seeing the emulation or is my data really gone. syslog fatjoe-diagnostics-20220905-1015.zip