Author Topic: unRAID Server Release 5.0-beta14 Available  (Read 75176 times)

Offline dgaschk

  • Hero Member
  • *****
  • Posts: 5805
Re: unRAID Server Release 5.0-beta14 Available
« Reply #495 on: April 28, 2012, 10:09:58 AM »
I am finally getting around to upgrading this weekend.  I have copied my 4.7 flash and backed it up in a couple places. 

I was preparing to do the upgrade and instructions look pretty easy, but notice up near the top  to uninstall all non-stock add ons.

At the risk of asking the obvious:  I have unMENU installed and a number of the addon's that can be installed from unMENU.
- APCUPSD
- BWM-NG - Bandwidth monitor
- htop & iftop - honestly not sure what these are and dont remember installing them myself.
- Monthly parity check
- Modify Mover
- NTFS-3g
- PCI-utils - again don't recall installing
- Clean Powerdown
- screen
There are a few others that say "installed, not downloaded" and I think these came in the box with 4.7 (IE therefore not downloaded by unMENU)

Then I also have SNAP installed but don't particularly need this.

So do I have to manually uninstall and remove these from the flash?  If so not totally sure how to go about doing that.

I think unMENU is not needed with 5.14, correct?  Will I need these addon's or are the in the package now?  the UPS, screen, monthly parity check, and maybe SNAP are important to me.  SNAP I can probably do without, not using it presently.

thanks for any help before I jump to fast!

Backup to go file and install the go file included with the distribution to disable all add-ons.
Include your VERSION and SYSTEM LOG for support issues
Unofficial Documentation  Check Disk Filesystems  The Analysis of Drive Issues  Console Commands 

Revert to stock system:                    Stock go file:
1. Rename the /boot(flash)/config/plugins directory.
2. Rename the /boot(flash)/plugins directory.
3. Rename boot(flash)/extra/.
4. Use the stock go file (boot(flash)/config/go).
                    #!/bin/bash
# Start the Management Utility
/usr/local/sbin/emhttp &

Offline stealth82

  • Member
  • **
  • Posts: 49
Re: unRAID Server Release 5.0-beta14 Available
« Reply #496 on: April 30, 2012, 11:43:35 PM »
All of them are attached to my ZOTAC - H67ITX-C-E main board (6 SATA ports).
Nothing odd to be reported on the syslog.
Try the following: set the spin down delay differently for those disks which won't spin down.

Click on the particular disk and change the spin down delay value there, say make it shorter than default.
To follow up: it worked. Thanks!