RADIatiON Posted June 10, 2008 Share Posted June 10, 2008 I tried to make the subject as short and descriptive as I can but here's the story. I just purchased two new Samsung Spinpoint 750GB HDs (HD753LJ). One of them I put in as the new parity drive (which is attached to my motherboard) and the other I added onto my Promise TX4 controller. The one that was attached to the Promise controller would not report a temperature status. I had a thought it might be related to the controller card so I swapped the drives around and put it on the motherboard controller as well and viola... it shows now. Not sure what or why but I figured others might be interested or if Tom or anyone wants some more info, just let me know. ps. I've now maxed out available connections on my first unRAID with just over 4.2TB of usable storage. Quote Link to comment
hawihoney Posted June 11, 2008 Share Posted June 11, 2008 Hi, check if SMART is enabled with this command: /boot/smartctl -a -d ata /dev/sdx Issue the following command for the drives with SMART disabled: /boot/smartctl -a -d ata -s on /dev/sdx In case you don't have smartctl on your machine you can download that tool in the download area. That worked for my Samsungs. You need to replace sdx with the appropriate device identifier. Regards Harald Quote Link to comment
RobJ Posted June 11, 2008 Share Posted June 11, 2008 Added to FAQ, here. Feel free to add, edit, or expand. Smartctl can be located here. Quote Link to comment
RADIatiON Posted June 12, 2008 Author Share Posted June 12, 2008 check if SMART is enabled with this command: ... Hey thanks for that... I don't think it applies in my case though as the drives report properly when connected directly to the motherboard but not when connected to the Promise controllers. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.