daniel.boone Posted March 24, 2010 Share Posted March 24, 2010 Completed with 9 drives plus parity 8 on board 2 from pcie sil monoprice card I have another 4 ports free on a pcie installed Adaptec 1430 I'll add the syslog again in a month for level 2 Mar 24 05:05:21 Tower kernel: md: sync done. time=29401sec rate=66443K/sec Mar 24 05:05:21 Tower kernel: md: recovery thread sync completion status: 0 2TB Hitachi parity with a 8.08 TB array There a few errors from my missing UPS. I didn't spot anything out of the ordinary. If you spot anything please let me know. I haven't had a chance to work on WOL so can't say if it works or not. I'll address both once I get a replacement APC UPS. cheers db syslog-2010-03-24.zip Quote Link to comment
terrastrife Posted March 27, 2010 Share Posted March 27, 2010 does all your disk sizes end in 552 bytes? Quote Link to comment
daniel.boone Posted March 28, 2010 Author Share Posted March 28, 2010 does all your disk sizes end in 552 bytes? All but the last one yes Quote Link to comment
terrastrife Posted March 28, 2010 Share Posted March 28, 2010 thats the HPA bullshit Quote Link to comment
daniel.boone Posted March 28, 2010 Author Share Posted March 28, 2010 thats the HPA bullshit I don't think so. I recently swapped my motherboard so all the drives were previouly formated and part of a array (asus). The sizes reported are consistant with my old motherboard. HPA was disabled on the new MB (Gigabyte) before I started the swap My array is basically all 1TB drives so it should report as "976,762,552" or am I misinformed here? Quote Link to comment
terrastrife Posted March 28, 2010 Share Posted March 28, 2010 fromw hat i understand pretty much every hdd in teh last 10 yeras will end at 552 bytes. Quote Link to comment
prostuff1 Posted March 29, 2010 Share Posted March 29, 2010 Completed with 9 drives plus parity 8 on board 2 from pcie sil monoprice card I have another 4 ports free on a pcie installed Adaptec 1430 I'll add the syslog again in a month for level 2 Mar 24 05:05:21 Tower kernel: md: sync done. time=29401sec rate=66443K/sec Mar 24 05:05:21 Tower kernel: md: recovery thread sync completion status: 0 2TB Hitachi parity with a 8.08 TB array There a few errors from my missing UPS. I didn't spot anything out of the ordinary. If you spot anything please let me know. I haven't had a chance to work on WOL so can't say if it works or not. I'll address both once I get a replacement APC UPS. cheers db Finally got this added to the Hardware Compatibility Page. It took me a while (been busy looking for a house) but everything looks good. If/When you get to level 2 let me know by updating this thread and sending me a PM. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.