JorgeB

Server rebooting on its own it's almost always a hardware issue, but enable the syslog server and post that after a crash in case there's something logged.

You didn't need to do a new config, just what I've posted above, but that will also work.

Let the rebuild finish.

Make sure the emulated disk is mounting and contents look correct before rebuilding on top.

You cannot have a new parity a a new disk at the same time, what was the original array state? If there's no data to recover do a new config

Just rebooting should not cause issues, enable mover mover logging, run the mover, post the diagnostics.

Please use the existing plugin support thread:

It will work with a single DIMM, at least it should.

Stop the array unassign parity start array stop array re-assign parity start array

poll cfg is still showing as a mirror, try this: unassign all pool devices start array stop array assign only the old device start array stop array now assign the new device together with the old one start array If this doesn't work post the output of zpool import

Usually it won't accept any value, try 300, or 150.

If you are using a different flash drive the license needs to be transferred, you can do that yourself or contact support and have them do it.

Looks like it needs this module: https://cateee.net/lkddb/web-lkddb/QEDE.html I've asked LT to add it, hopefully for the next release.

It does appear to happen with some flash drives, I see it with one of mine.

Please post the diagnostics.