unable to assign a replacement drive.

I had a drive die. I've pre cleared a drive. Stop the array. Whenever I go to assign the replacement drive, after I select the drive the web page just refreshes and shows the drive as unassigned. I then go start the array again and I get a file not found message.

What version unRAID? What browser? Any adblockers in your browser?

sorry i forgot to include that info.

6.2.0-rc5. I have tried both Chrome and Safari. Not running any adblockers

Are all your plugins up-to-date?

Plugins are up to date and I disabled Docker. Logs attached.

Starting the array works like normal except after I try to add the drive. I always get the file not found error after trying to start the array after I try to add the drive.

tower-diagnostics-20160912-1008.zip

Do you have another browser you could try? Maybe try from another computer on your network?

Have you tried it without plugins by booting in SAFE mode? If it still doesn't work in SAFE mode then you might post to the RC5 release thread and link to this one.

I only have the one computer at home. I've tried from my work computer as well with the same result. I don't have any way to try from windows machine.

I will bring a monitor home so I can try safe mode.

I will also go ahead and post in the release thread and link to here.

Thanks for the suggestions!

I went back to RC4 and was able to add the new drive

If it still doesn't work in SAFE mode then you might post to the RC5 release thread and link to this one.

[*]Have I successfully tested this bug with all my plugins disabled (booting into safe mode)?

[*]Can I recreate the bug consistently and have I documented the steps to do so?

[*]Have I downloaded my diagnostics from the unRAID webGui after the bug occurred, but before I rebooted the system?

Do not post about a bug unless you can confidently answer "Yes" to all three of those questions.

 

Sorry I should have caught the part about your incompatible plugins.