wup

Bonding two internet connections for specific container

3 posts in this topic Last Reply

Recommended Posts

Hello! 

 

First time posting here, so please be kind lol

 

I have spent quite a bit of time trying to figure out how to bond my two internet connections for a specific container. My motherboard has two gigabyte network cards (https://www.supermicro.com/products/motherboard/Xeon/C236_C232/X11SAE.cfm) and I have two internet connections, 120/10 and 100/10. (down/up).  I primarily want to bond the two internet connections for Nzbget, since the newsgroups I am using support multiple IPs and connections.  Attached is an image of my current docker setup. How do I go about doing this, as I don't want to worry about changing IP address and Plex access issues.

 

Thanks so much for the help!

Docker Setup.png

Share this post


Link to post

Probably best and easiest to set up a router in a multi-WAN config to load balance the two Internet connections.  Can be done with pfSense and probably some higher-end consumer routers that market as such or those that can run multi-wan tomato or equivalent(?) dd-wrt firmware.  PfSense probably has the best documentation to do such a task and will probably give you finer balancing controls.  You won't be able to get a since connection that is 220Mbit wide, rather it will work in a round robin scenario with each new connection in concert with your load balance controls (weights and rules).

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


Copyright © 2005-2018 Lime Technology, Inc.
unRAID® is a registered trademark of Lime Technology, Inc.